Archive for category Circuits

IV-6 Vintage Soviet Numitron Tubes

Recently I have acquired some IV-6 Soviet Numitron Tubes. Numitron tubes are just similar to normal vacuum tubes, but they run on low voltage and current hence making them highly attractive for low power project use.

Read the rest of this entry »

Advertisements

, , , ,

1 Comment

Atten APS3003S/3005S Variable Power Supply – Review and Teardown

The Atten APS 3003S/3005S is an entry-level power supply designed for use by hobbyist and by students in school labs. The two models, the APS3003S and APS 3005S are almost exactly the same, but there are slight design differences and specs between the pair. The 3003S features a maximum current output of 3A and the fan is constantly on. The 3005S model features a maximum current output of 5A and the fan is controlled by a thermostat, which monitors the temperatures of the heat sinks from the two power transistors and discussed later on. This series of power supplies is usually seen sold on eBay for a relatively cheap and fair price of around about $100, which means that it is easily obtainable for both hobbyist and school use. It can output 30 Volts at 3 or 5 Amps depending on the model and it does also have some very promising specs. Every lab needs a proper power supply for many purposes such as testing electronic circuits, charging batteries and for just burning things up :D. I’ve been needing a proper power supply for my lab for a while now and after searching for a bit I decided to buy this power supply because I was unable to find another power supply in the same price range with the specs that this unit offered. Now after receiving and using the power supply for a bit, I am able to provide a full review and a small teardown of the supply.

Read the rest of this entry »

, , , , ,

9 Comments

Multimeter Temperature Mod

Remember that $4 multimeter that I took apart? Well, I still have it. And its not very reliable nor useful. So, I have decided to make it useful! How you may ask? Well, I am going to make it display temperature so I can estimate the temperatures of different components and heatsinks. This is based on a tutorial by Embedded Lab, so I take no credit for the idea of this build. Here is the link to the project: http://embedded-lab.com/blog/?p=4951. I was thinking about doing a tutorial, but it’s already on Embedded Lab and I don’t want to plagiarise so I am just going to go through how I built this and a few modifications that I have made to the original circuit.

Read the rest of this entry »

, , , , , , , ,

Leave a comment

Square Wave Generator with Adjustable Frequency 1Hz to 1Khz


Recently I needed a square wave to mess around with some filters, however I didn’t have one. So I decided to build one based on the ever so popular 555 timer chip!  My inspiration is from the Australia electronics magazine Talking Electronics, the project is in Issue 3. After a bit of research about the 555 and how it works, I created the final circuit ready to be used. The circuit is below (I still don’t have a proper circuit schematic drawer program, so please excuse the illustration):

Read the rest of this entry »

, , ,

1 Comment